USER’S GUIDE & SAFETY MANUAL Running Line Tensiometer
10 Rope Installation !CAUTION: Running Line Tensiometer is not for use with steel cables of steel rope. Rope must follow a straight path over the c
11 Power Connection Electrical power is supplied to the Electronic Control Box through the power cords located on the side of the unit.
12 2. Select unit of measure pounds (Lb) or newtons (N). This must be done with no load on the RLT. On the RLT the display reads newtons and the ch
13 Limiter switch is in the “ON” position the puller will stop pulling when the tension limit is reached (See Figure 10) Chart Reco
14 Figure 12 Figure 13 Figure 14
15 2. Set to Record Mode: If you are already in the Record Mode screen, use the ▲ and ▼ buttons to scroll to “ON”. If you are starting from the ch
16 Operation Instructions To Operate the Running Line Tensiometer Safely and efficiently, the user must have a working knowledge of the Condux Cabl
17 !CAUTION: Always wear protective equipment: hard hat, safety glasses, safety shoes, and work gloves. !WARNING : Stay clear of the rotating capst
18 Appendices Recommended Working Load for Rope The recommended working load is determined by taking the average tensile strength of new rope und
19 Troubleshooting Guide Problem: Solution: Digital display is not functioning • Turn Electronic Control Box pwer switch ON • Check all electric
2 Important Safety Notice WARNING: When using electric tools, basic safety precautions should always
20 Warranty Information
3 Table of Contents General Information………………………………………. 4 Safe Operating Practices………………………………..5 Equipment Set Up……………………………………….
4 General Information General Product Use A. The Condux Running Line Tensiometer, used with the Condux CableGlider® cable puller (or other rope c
5 Safe Operating Practices Important Safety Instructions Electrical Requirement 1. This RLT should be grounded while in use to protect the operat
6 7. Do not use the RLT if the switches or buttons are malfunctioning. Have them replaced by an authorized service center. Disconnect Tools 8. Al
7 Maintain RLT with Care 21. Follow instructions for changing accessories. Inspect the RLTs plugs regularly, and if damaged, have it replaced by an a
8 3. DOWNGRADE OR DISCARD: When rope has been subjected to forces or conditions that reduce its strength, it should immediately be downgraded (used
9 Equipment Set Up Installation of the Mechanical Sensing Unit The Mechanical Sensing Unit is designed to mount directly to the frame of Condux Cab
Kommentare zu diesen Handbüchern